C.S. Osborne 1-1/2″ Foam Hole Cutter

Use this Foam Hole Cutter to cut precise, perfectly sized holes in your polyurethane upholstery foam for button tufting. The extremely sharp carbonized cutting edge cuts through seating foam with ease. The hole in the foam will allow the button to sink into the foam for a professional-looking tufted upholstery piece. The cutting cylinder is 3 inches, but you can cut through a maximum thickness of 5 inches by compressing the foam when drilling. This hole cutter attaches to a drill press or a handheld power drill.

When using the hole cutter, drill straight down to cut your foam, and then keep the drill engaged as you lift the hole cutter out. Keeping the drill on will pull the cut hole out of your foam piece. Place a cutting mat underneath the foam to protect your work surface.

Tip: Spraying inside and outside the cylinder with a dry silicone lubricant or McLube™ Sailkote can help promote a smooth cutting experience.

Features:

• Sharp carbonized cutting edge drills clean, precise holes.
• Length of holding tip: 7/8 inch.
• Length of cutting cylinder: 3 inches.